St100LM025 Ovly NOT loaded

[Tawfeek]

Hello
power normal .no clicking . always busy
terminal output is :-


ActiveFW : 00
FWVer : 0001
SATA PLL cal done
DDR size detected = 16MB

DDR size detected = 16MB

*PA_TI5565*PA VID=0012 PN=0055 Rev=0000- PA_TI5565 Found
*PA_TI5565*PA VID=0012 PN=0055 Rev=0000- PA_TI5565 FoundU
S_0SO_1
SPU@31'C,5068mV
IS=5
CLA ..36/61
HO..OK
HO RPM=2123 OK
AC 1357
ST..OK
mS1 00000003
GT:415
SC(L):4118/-3
BE.N:28
LD..OK
SK C: 7820 H:0
Loaded FIT ( 0: 0: 1)
CalibTable Loaded. Rev:0x1B
ResoTable Loaded. Rev:0x01
Bump Limit Loaded. Rev:0x01
RRO1xTable Loaded. Rev:0x01
Fw Active 00
Ovly NOT loaded

eng>
_________________________________________

any clue please ?

[fzabkar]

I'm guessing that MOVLY001 is incompatible with the ROM code. MOVLY001 consists of two modules whose RAM load addresses need to match the ROM's FLASHTBL. If you can retrieve the ROM and MOVLY001, I can check them for you.

[Tawfeek]

Thanks Fzabhar . i can retrieve the ROM only for sorry

[MindMergepk]

have you tried starting drive with head 1 & 2 ?

[fzabkar]

i can retrieve the ROM only for sorry

This is what I would be looking for:
http://www.hddoracle.com/viewtopic.php?f=59&t=698

You might like to verify whether your PCB is native by comparing the YYWW date codes on the ICs against the manufacturing date on the label.

[Tawfeek]

have you tried starting drive with head 1 & 2 ?

i will tried to make head initialization in ram with no luck

[Tawfeek]

This is what I would be looking for:
http://www.hddoracle.com/viewtopic.php?f=59&t=698

You might like to verify whether your PCB is native by comparing the YYWW date codes on the ICs against the manufacturing date on the label.

that's good point . i will try it . many thanks