Unlock Seagate Password

[mmzhr]

Hi
For unlocking seagate hdd type this congen commands in level T

F"SECURITY_MODE_FEATURE_SET_SUPPORTED",00,22
F"SET_MAX_SECURITY_EXTENSION_SUPPORTED",00,22
F"SECURITY_MODE_FEATURE_SET_ENABLED",00,22
F"SET_MAX_SECURITY_EXTENSION_ENABLED",00,22

And Repair Bad Sectors With This Command

m0,3d,3,ffff,ffff,ffff,ffff,22

All Data Will Be Erased!!!

Good Luck

[mmzhr]

Instead of disabling the capability of the drive to handle the Security by Congen just get rid of the password to start with, either by ZOC script or by reading/editing the correspondent sys file ...

Thanks Spildit
Which Sys File Number?

[mmzhr]

Here :

http://www.hddoracle.com/viewtopic.php?f=83&t=874

And here :

http://www.hddoracle.com/viewtopic.php? ... 718#p10717

Sys File 30A

1.jpg

2.jpg

Thanks You Are Genius!!!

[mmzhr]

Thanks You Are Genius!!!

Sure !!! Of course I AM !!!

How Can i solve seagate 7200.11 and 7200.12 read problem?

[mmzhr]

How Can i solve seagate 7200.11 and 7200.12 read problem?

Depends of the problem with the drive.

Maybe bad heads ?
Maybe bad surface ?
Maybe firmware problem ?
7200.11 might have LBA 0 or stuck at BSY.
7200.12 might have partial access problem.



But there are 2 easy ways to "fix" this.

1 - If you don't need the data buy a new drive.
2 - If you need the data send the drive to a pro.

i'm sure all 7200.11 have full lba and also 7200.12 dont stuck in partial access

[mmzhr]

So what is the problem with the drive ? You can't read some sectors ?

Buy Hitachi/HGST instead and don't use Seagate ever again, or at least anything newer than 7200.10 (ST-10)....

i solved read problem in 7200.11
i cleared P List with
/1G6A
then rebuild P List
/AP
then Rebuild translator with
m0,6,2,,,,,22 and then
m0,6,3,,,,,22
and problem solved for 7200.11 all lba is accesible
but this method dont work on 7200.12
why?

[mmzhr]

:shock:

No comment ....

what happend to you

[data-medics]

I hope you were just trying to refurbish that drive and not get data back. It's gone now.

[mmzhr]

I hope you were just trying to refurbish that drive and not get data back. It's gone now.

i'm trying to repair this drive

[MindMergepk]

then rebuild P List
/AP

are you sure this will rebuild Plist ???

[mmzhr]

then rebuild P List
/AP

are you sure this will rebuild Plist ???

sorry this move G To P List

[Masterclass]

i cleared P List with...

Can you stop posting stupid messages with dangerous commands?

[mmzhr]

i cleared P List with...

Can you stop posting stupid messages with dangerous commands?

i'm posting for advanced users not stupid users

[Masterclass]

i'm posting for advanced users

Decent engineers never used these silly commands.