ST380815AS

[unknown]

Hello
The drive in topic is always busy.
I can read sectors by terminal, but very very slow.
Is there any suggestions?
Thanks in advance.
Terminal output:
4096k x 16 DRAM
NHAWK - 1_Disk S-41 10-23-06_16:40
HM SFI
!
(P)SATA Reset
Failed sys sect. write! Nwt Er 33 RdWr 137dc.00.0003

Read Ver Retrys

Read Ver Retrys

Read Ver Retrys

Read Ver Retrys

Read Ver Failure!
Failed sys sect. write! Nwt Er 00 RdWr 137dc.00.0003
Unable To Load Overlay 01|000A

T>

[unknown]

ATA overlay is damaged so you can't access the drive by ATA.

APP code is ok as you have level T and not F. Adaptives and Defect lists should be ok.

Try to boot from loader. Maybe you can extract the data if you load the drive by a loader with correct FW version. This should load ATA overlay on RAM.

Also if you have FW for your drive you can try to replace ATA overlay as long as you use correct one.

Or you can try to read ATA overlay from your drive and see if you are lucky ...

Thanks for the input.
I will try with matched loader.
thank you

[Tomset]

Er 33 RdWr - not load adаptive UA

[unknown]

Er 33 RdWr - not load adаptive UA

Interesting.

Can you try R2 at T> ?

Failed sys sect. write! Nwt Er 33 RdWr 137dc.00.0003

Read Ver Retrys

Read Ver Retrys

Read Ver Retrys

Read Ver Retrys

Read Ver Failure!
Failed sys sect. write! Nwt Er 00 RdWr 137dc.00.0003
Unable To Load Overlay 01|000A

T>R2
Code - 74 Track FFFFF(137DC).0.012 Sns FFF Rty 027F.FF.80FF Rtf 1800 LBA 000005E5
T>

[unknown]

Case solved by transferring by terminal.
Data needed was some XLS's

Thank you very much.