Need loader

[unknown]

Spyg2
Ver : 00000008

Thanks in advance

[unknown]

Anyone know the two points of read channel (TV9&TV10) for (2060-810035) ?

Much appreciated

[Cleanroom]

Hope this helps

Attachments

11.zip

(684.07 KiB) Downloaded 300 times

[fzabkar]

Anyone know the two points of read channel (TV9&TV10) for (2060-810035) ?

Much appreciated

Yes. If you upload a photo, I'll show you.

[unknown]

Hope this helps

Many thanks

Anyone know the two points of read channel (TV9&TV10) for (2060-810035) ?

Much appreciated

Yes. If you upload a photo, I'll show you.

Sorry for the bad quality of the photos :

Attachments

[unknown]

Drive model : WD50NDZW-11BCSS1

Tried different loaders without luck. (reset power and not accepted loader)
The drive is always busy, tried loader with and without SA access in ROM but no luck.

[fzabkar]

The photos are too small. Sorry.

[unknown]

Drive model : WD50NDZW-11BCSS1

Anyone got resources for this drive?

[fzabkar]

With the PCB removed from the HDA, measure the voltages at the indicated read/write channel test points (with respect to ground).

I expect that the read channel will measure 0V.

Attachments

Rd_Wrt_Chan.jpg (103.62 KiB) Viewed 7755 times

[unknown]

Thanks a lot Mr. Franc for your efforts. Much appreciated.

Case closed.

[Good Stones]

Hello there,
I have a wd Drive model : WD50NDZW-11BCSS1, rom version 00000008, same as your recent case.
Drive was dropped and was opened by another lab, after head change, no spin down, however drive canot be id fully.

Have you recovered your case and would like to share the rom and loader? Thanks.

Have a good day.

Eug