Hey so my hard drive died and im attempting to fix it

[mah70]

its a seagate hdd 1tb ST1000DM010

and i found this thing that has ZR00 OR 2R00 on it which read different resistances at zero times and it beeps when i use the multimeter for continuity it reads 45,80,70,24 ohms and between and the hard drive died randomly one day and it makes 0 sound when plugged in
any help would be appreciated , pics of the component attached im not sure if thats the TVS Diode or not and ill attach a clear pic i found online of the whole circuit

whats this ZR00?

pic of the whole circuit

[Lardman]

https://www.digikey.co.uk/en/resources/ ... istor-code

Check the 0 ohm resistors on the 12v and 5v rails near the sata connector for continuity.

[mah70]

https://www.digikey.co.uk/en/resources/conversion-calculators/conversion-calculator-smd-resistor-code

Check the 0 ohm resistors on the 12v and 5v rails near the sata connector for continuity.

they all give me around 1-3 ohms and they beep

[mah70]

https://www.digikey.co.uk/en/resources/conversion-calculators/conversion-calculator-smd-resistor-code

Check the 0 ohm resistors on the 12v and 5v rails near the sata connector for continuity.

oh and the thing that says ZR00 or 2R00 gives me 2 ohms

[Lardman]

oh and the thing that says ZR00 or 2R00 gives me 2 ohms

Did you look at the link even ? If you're going to attempt a board repair you need to have at least a basic understanding of components a make an attempt to learn it pretty fast. None of the resistors appear to be your issue.