ST4000VX013-2XG104 SKYHAWK "No HOST FIS-ReadyStatusFlags 000

[Thedatarecoverylab]

Hello friends its a 4th SKYHAWK B2 family, Drive stays busy with the following terminal error:

Trans
Tech Unlock Handshake: 0xF8168470
Reply:
Rst 0x0100M
VM0183
CV11
SAdd:0x0055D9A7
RW subfile error 2046
SAdd:0x0055DB6D
RW subfile error 2046
SAdd:0x0055DB6D
SIM Error 2046 LBA 0000000000031688 FD FC373028
RW Error 00000080
RAP MC size:DC
NVCScram Saved HB Size:0000
LD:
PP:
WCD
Power On Replay Disabled
FormatInfo Case1
FCAdd:0x0055814B FFs=0x00011E09
[wmp:00000008]
No HOST FIS-ReadyStatusFlags 0002A1A1
ASCII Diag mode

I tried translator regeneration now drive comes ready with full id but sector looks shifted , when i write back the original translator i get the same error "No HOST FIS-ReadyStatusFlags 0002A1A1"

I have attached the original rom and translator as well

Attachments

4tb skyhawk.rar

(637.4 KiB) Downloaded 20 times

[MindMergepk]

translator regen was not a good move on this drive am afraid.
what command you use for translator regeneration ?
are there any entries in NRGlist ?

[Thedatarecoverylab]

translator regen was not a good move on this drive am afraid.
what command you use for translator regeneration ?
are there any entries in NRGlist ?

I have taken original 28,35,93,1b backup and not able to open NRGlist when i try to edit NRGList drive reboots

[pepe]

the attached file (28) is empty, is this the original translator? If so, somebody seems to have been there already...

pepe

[Thedatarecoverylab]

the attached file (28) is empty, is this the original translator? If so, somebody seems to have been there already...

pepe

Hi pepe, attached 28 is the original translator, and am sure the drive is not been into any other data recovery center

[MindMergepk]

the attached file (28) is empty, is this the original translator? If so, somebody seems to have been there already...

pepe

Hi pepe, attached 28 is the original translator, and am sure the drive is not been into any other data recovery center

was drive originally throwing LED error and you short the read channels on it.. ?