Switch to full style
Data recovery and disk repair questions and discussions related to old-fashioned SATA, SAS, SCSI, IDE, MFM hard drives - any type of storage device that has moving parts
Post a reply

ATA Security locked Seagate IronWolf Pro 10TB

22 minutes ago

Hi everyone,

I bought a lot at a public auction (from ALLIANZ): a decommissioned Synology NAS (DS1817+) with 6x Seagate IronWolf Pro 10TB drives inside.
I have the invoice and the auctioneer’s certificate, so this is a legitimate purchase.

5 of the 6 drives are perfectly healthy (clean SMART, no reallocated sectors, readable). The 6th one is ATA Security locked and I can’t get past it.

Drive: ST10000NE0004-1ZF101, Firmware EN01, SATA, 9.1TB usable, SerialNumber :ZA22LWJV
System: fresh Debian 13 install, drive connected directly to an ASRock B550M Pro4 SATA port. (no HBA)

Code:
dparm -I output (relevant part):

Security:
    Master password revision code = 65534
        supported
        enabled
        locked
    not     frozen
    not     expired: security count
        supported: enhanced erase
    Security level high
    866min for SECURITY ERASE UNIT. 866min for ENHANCED SECURITY ERASE UNIT.


It’s locked but not frozen, so I know a straight unlock attempt should theoretically work with the right password, i just don’t have it.

All attempts to unlock with hdparm or sedutil-cli return the generic
Code:
SG_IO: bad/missing sense data
message, and the drive remains locked every time I re-check with hdparm -I

Is there a way to unlock it ?
Post a reply