problems with regenerating translator

I tried to regenerate translator with pc3000pci and got Error 51/04. Drive is WD800JB-00ETA0. Does anybody know what that error means?

Here is pc3000pci log:
Techno mode key:
HDD geometry loading.................... : Ok
Cyl Count............................... : 87906
Head Count.............................. : 2
SPT..................................... : 820

RAM:
Zone allocation table................... : Ok
ROM version............................. : 77.3J.
SA FW version........................... : 77.3JW
Link table version...................... : 07.46.

Serial ROM:
Read ROM................................ : Ok
Heads configuration..................... : From map
Heads number............................ : 2
The number of heads in use.............. : 2
Disabled heads.......................... : No
Head map................................ : 0,1

Service area:
Modules table loading................... : Ok (Copy 0)
Configuration loading................... : Ok
Master Password......................... : "WDCWDCWDCWDCWDCWDCWDCWDCWDCWDCWD"
User Password........................... : has not been set
Translation overlay checking (Copy 0)... : Module reading error : WD Techno Read Error C/H/S: -3/0/336 - Device Error Detected 59/40 (UNC)
Translation overlay checking (Copy 1)... : Module reading error : WD Techno Read Error C/H/S: -3/1/333 (15000 ms) - Drive is not ready

HDD ID reading.......................... : Ok
Translator regeneration
Regeneration method..................... : Use P-List only

Error 51/04

Looks like a damaged service area to me.

Is there any solution to recover the data when SA is damaged?

Yes check the service area for errors then add them to P-List .

pixprit
If you have PC3000 you should know how to fix it.
Check out the manual, acelab forum etc.

In my case it is not so easy, because regenerating translator didn't work and I can't format SA also. Modules reading is very unstable - sometimes (when hdd is cold) it reads most of the modules and sometimes I can't even read the P-list. Didn't found nothing about this case from WD manual. Fortunately I have a backup of all A-importance modules and other modules from another WD800JB-00ETA0. Any solutions?

check firmware zone please, check copy0 and copy1 about translator models, if them dosent same or damaged then repair them. you can use copy0 repair copy1, or 1 repair 0 if one of them good.

Or use Composite reading .

Too bad.
I wouldn't try to write anything into SA with such unstable heads.
You get ABORT error on regenerating translator because it can't read P-List. You can try to restore it but with such heads there is a chance you screw up and damage something else.

Hi you can try a PCB change with reads getting worse as drive warms up it is sometimes the ST chip on the PCB. You can get similar PCB and re-write with the one from original or change rom chip & try again. Sometimes it is a dodgy pre-amp chip on the armature and this won't help, but this has worked for some drives for me in the past.