Data recovery and disk repair questions and discussions related to old-fashioned SATA, SAS, SCSI, IDE, MFM hard drives - any type of storage device that has moving parts
September 6th, 2007, 15:41
I have a Seagate ST320014A with a defective pcb and a good working drive ST310014A FW 3.09.
1. Can I swap the defective pcb with the pcb from a ST310014A modell to save my data?
2. Is it necessary to flash the firmware from ST310014A to ST320014A?
3. I have found a ST320014.bin, but how i can flash it? Which Flashutility and where can I get it?
Best Regards.
September 12th, 2007, 13:55
If fw version is same then u can swap .
Powered by phpBB © phpBB Group.