Data recovery and disk repair questions and discussions related to old-fashioned SATA, SAS, SCSI, IDE, MFM hard drives - any type of storage device that has moving parts
May 17th, 2008, 16:19
Platters Moter don't start ,
i check the PCB ,I check the Platters, i check the Heads everything OK!
but the Moter don't spin...
Any idea ....
May 17th, 2008, 19:21
Did you replace the PCB? Does the spindle spin manually? Have you checked the motor windings with a multimeter?
May 18th, 2008, 2:02
yes i check all that ...
what you means manual , "if turn , yes it's turn "
i know , i think I'm sure is the moter...
what I do not know is with what way i must changed without problem "do not lose the step from platters"..
May 18th, 2008, 9:37
If you're looking for a way to swap platters, Salvation sells a tool.
May 19th, 2008, 0:04
WD250s generally have 6 heads. Swapping platters is not recommended if you are an amateur and you really need the data. That's a lot of heads to load and unload simultaneously.
Jono
Powered by phpBB © phpBB Group.