Data recovery and disk repair questions and discussions related to old-fashioned SATA, SAS, SCSI, IDE, MFM hard drives - any type of storage device that has moving parts
May 30th, 2008, 6:46
Hi guys
I have a 250 WD HDD that was dead and i put a PCB for 120 GB HDD same model and it powered on, now my dilemma is its recognized as a 120gb HDD and Sometimes 8gb and after trying to boot the machine, it refused, then i tried connecting it using USB but it cannot be recognized. Please help, i need to recover the Data.
May 30th, 2008, 11:20
You need to place a correct board, firmware and head map
It sounds like you might have 2 out of 3 correct.
Read as much as possible about U12 chip.
June 4th, 2008, 22:40
you must change U12 chip !!!
Powered by phpBB © phpBB Group.