WD2000BB-00DAA0 will not sleep

[acforensics]

Hi Gurus,

I'm trying to do a hotswap with this drive for a dead drive(stays busy) and I cannot get it to go into standy mode. When I send the standby command, I get ERR and ABR status registers lit. Not sure if this helps, but when I load the drive up, I get: "Device Error Detected - 59/01 (AMN)". Also, a few of the B modules show errors, but I cannot repair them as both copies are bad.

I've tried sleep mode in both PC3000 and Salvation Data.

Does this sound like a module problem?

Thanks for your help!

A

[beto]

Hello acforensinc?

wich was the problem on first before did hot swap ? Knocks, lost readiness? reach DRDY DSC?, BSY? and u donnor did u check if u donnor has same FW version and head map?

Best Regards