Data recovery and disk repair questions and discussions related to old-fashioned SATA, SAS, SCSI, IDE, MFM hard drives - any type of storage device that has moving parts
October 30th, 2003, 0:48
we have the above mentioned model of ibm drive.
when connected to pc-3000at, it takes few minutes to go ready, but after launching the corresponding utility to test the drive it says "unidentified logical parameters" , "error reading NV-RAM" , "module table cannot be read"
we started performing the servo test, it starts at 200ms head access time and very slow.
surface scanning gives all errors.
we are able to read the ROM, NV-RAM structure
when we try to write the FIRMWARE, it comes out with error.
can anybody advice
Powered by phpBB © phpBB Group.