Good Day
i have a problem with Iomega Star Center Ext HDD 2x250 GB seagate IDE in it is detecting in network and showing 0GB capacity Thanks for any Response.

You must connect disk directly to the sata/pata cable. What model of disk do you have?

_________________
Flash Killer - everyday new resources (pinout, XOR, ECC,config) for flash devices

Good Day
Thanks for reply it is ST3250823A seagate IDE 250GB i connect directly to PC checked with R studio software it shows 4 partitions inside of Each Drive do u think it is Raid0 ??

Good day
check this link for more Details about Drive https://iomega-eu-en.custhelp.com/cgi-b ... d=1snC77Rj

Have You access to data? Is data ok, or maybe picture is striped?

If it is RAID 1 - you have exactly copy on both of the disks.
If it is RAID 1 - the best way you should use DMDE for image the disks, and then try to rebuild the RAID.

_________________
Flash Killer - everyday new resources (pinout, XOR, ECC,config) for flash devices

Thanks
Arvika but it has RAID0 i checked with Runtime Raid reconstructor trying to copy disk in new Drive.

Sorry, in second line should be:
If it is RAID 0 - the best way you should use DMDE for image the disks, and then try to rebuild the RAID.

Addition:
DMDE have a nice function to build virtual RAID 0

_________________
Flash Killer - everyday new resources (pinout, XOR, ECC,config) for flash devices

Good day
i used Run Time Raid reconstrcutor i configure Raid0 and copied in 1 TB External HDD it has Xfs partition i Run UFs explorer for Data Recovery it shows some Data but not with Structure most of the data is corrupted if any one face same Problem please share u r Experiance this is Drive Model check link https://iomega-eu-en.custhelp.com/cgi-b ... d=YZgP8yRj

on one face same problem like this????

you have to determine raid starting sector, block size and disk order. then run your ufs explorer.