View topic - Fujitsu 2.5 Head Configuration

Main » Forums home » Conventional hard drives

All times are UTC - 5 hours [ DST ]

Fujitsu 2.5 Head Configuration

Page 1 of 1

[ 3 posts ]

Previous topic | Next topic

Author

Message

fbaron3

Post subject: Fujitsu 2.5 Head Configuration

Posted: May 25th, 2010, 12:16

Joined: May 25th, 2010, 12:00
Posts: 2
Location: United States

Is there anything on the drive that would identify the configuration of the head assembly. I have purchased 2 donor drives with matching Model #, Type, Part#, Firmware but the single head was on top of the platter unlike the original that was on the underside of the platter.

Model #: MJA2080BH
Part#: CA07083-B56000DL
Firmware: 00850019
Type: G2
ID: YTTN

Top

pcimage

Post subject: Re: Fujitsu 2.5 Head Configuration

Posted: May 25th, 2010, 12:45

Joined: November 29th, 2006, 10:08
Posts: 7864
Location: UK

Not usually, better to buy a 160Gb model then you are sure to get the head you want.

Often do this with older Fujitsu drives.

_________________
PC Image Data Recovery
http://www.pcimage.co.uk

New!! HDD-PCB.COM for all your PCB and donor HDD requirements!

Top

fbaron3

Post subject: Re: Fujitsu 2.5 Head Configuration

Posted: May 25th, 2010, 15:03

Joined: May 25th, 2010, 12:00
Posts: 2
Location: United States

Are there any other considerations I would need to be concerned with? I found the following Model Model MJA2160BH, seems to be in the same family of drives just double the size so I am assuming it would be a single platter with 2 heads. There are no issues with PCB, firmware, etc with a different head stack?

Top

Page 1 of 1

[ 3 posts ]

Main » Forums home » Conventional hard drives

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: Google [Bot] and 56 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum