Data recovery and disk repair questions and discussions related to old-fashioned SATA, SAS, SCSI, IDE, MFM hard drives - any type of storage device that has moving parts
May 15th, 2008, 5:05
Hello,
I have MHV2120BH drive with burned PCBA.
I can't unsolder the FW on the board.
How can I do for rebuilt compatible PCBA ?
FW on Customer PCBA : CB1C
FW on Spare drive : CB9B
Thanks
Misioux
May 15th, 2008, 10:36
You can use a board from a drive with the same firmware. No big deal.
July 6th, 2010, 10:23
Could someone reveal which of the tons of numbers on the drive is the firmware version?
Thank you!
July 6th, 2010, 11:55
chipmunk wrote:Could someone reveal which of the tons of numbers on the drive is the firmware version?
Thank you!
Look on the PCB for the word REV. NO, the line directly below this should be your firmware version.
Powered by phpBB © phpBB Group.