Data recovery and disk repair questions and discussions related to old-fashioned SATA, SAS, SCSI, IDE, MFM hard drives - any type of storage device that has moving parts
July 27th, 2010, 11:29
hello. i have a Maxtor Plus8 40Gb. i connect it to the ddi and it is not recognised (the model and LBA when i press F11)
there is only an ERR report. i supose there is a PCB issue. any help would be appreciated
July 27th, 2010, 11:34
That model does not have PCB problems usually. Chance of PCB failure is 1 in a 200.
July 27th, 2010, 13:46
harddrivespecialist wrote:That model does not have PCB problems usually. Chance of PCB failure is 1 in a 200.
Agree more than likely it is in the modules of this drive. Do you have any other tools to work in the SA and fix this one with?
July 27th, 2010, 15:36
Did you make sure that the drive jumpers are set for master?
July 27th, 2010, 17:45
do you have report of others tools?
July 28th, 2010, 1:58
Check jumpers and try with Mhdd, if no joy check pcb then SA.
Powered by phpBB © phpBB Group.