In need of replacement PCB for a Western Digital hard drive

Data recovery and HDD repair discussions

Data recovery and disk repair questions and discussions related to old-fashioned SATA, SAS, SCSI, IDE, MFM hard drives - any type of storage device that has moving parts
Post a reply
ewarias
  • ewarias
  • Posts: 1
  • Joined: October 22nd, 2011, 22:26
  • Location: California

In need of replacement PCB for a Western Digital hard drive

October 22nd, 2011, 22:46

I have a WD1001FALS SATA hard drive that has damaged SATA terminals, I either need to replace the PCB (WD 2061-701622-800-02P) or have someone replace the SATA terminals on my PCB.

Please contact me if you are able to help! Thanks :)
fzabkar
  • fzabkar
  • Posts: 16960
  • Joined: September 8th, 2009, 18:21
  • Location: Australia
  • Website

Re: In need of replacement PCB for a Western Digital hard dr

October 22nd, 2011, 23:05

If the SATA power connector is damaged, then you could hard-wire a 4-pin Molex connector to the +12V and +5V pins on the PCB. The +3.3V pins are not used.

http://pinouts.ru/Power/sata-power_pinout.shtml
http://pinouts.ru/Power/BigPower_pinout.shtml
Post a reply
Switch to full style

Powered by phpBB © phpBB Group.

Board index