hi,
I need compatible ATA module (0011) for this one WD5000AAKX-001CA0

Rom FW Version: 0003002P

Thanks in advance, fast response required

_________________
__________
There is no substitute for education and experience
THANK YOU
SHAHI
shahi.mahbub@gmail.com

Thx for the quick reply Tomset,

do u have full resources in SD format?

_________________
__________
There is no substitute for education and experience
THANK YOU
SHAHI
shahi.mahbub@gmail.com

Update ---
In this case, when I write it , its successful but after power reset it's lost again.

Then I used LOAD ATA (MANUAL), drive comes to ready, and LOAD FROM HDD Shows everything fine, even under sector view everything shows ok.
after that, I wrote again the ATA MODULE, but still after power reset everything lost.

Thinking for switching for cloning by keeping the power on.
but without the above trics...
Do u think somewhere else need to be fixed to make it working?

_________________
__________
There is no substitute for education and experience
THANK YOU
SHAHI
shahi.mahbub@gmail.com

Update -
After switching to CLONE by keeping power on... it's very slow...

Did SLOW REPAIR, SMART RESET... nothing worked...

I see I must make it working first (not virtually to RAM)...
Do you have idea what to do next to make it smooth to go on...!

_________________
__________
There is no substitute for education and experience
THANK YOU
SHAHI
shahi.mahbub@gmail.com

Hello guys,
latest update: after READ/WRITE test....

HEAD 0 and 1 READ ONLY

Any idea about dealing READ ONLY HEAD for WD?

_________________
__________
There is no substitute for education and experience
THANK YOU
SHAHI
shahi.mahbub@gmail.com