Hello
I have a 750gb Seagate Momentus 7200.5, model ID ST9750420AS.
I get> HDD does not support set max LBA
and> Recalibrate error Device error detected "ABR" 51/04 .
drive capacity shows zero MB.
LBA is set everywhere to minus one "-1", cannot be changed.
What should I look out for?
Pavel

Sounds like a firmware issue, but what is the drive's mechanical behavior? Any weird sounds.

_________________
Hard Disk Drive (HDD), Solid State Drive (SSD, SATA, NVMe, etc), USB Flash Drive and RAID Data Recovery Specialist in Massachusetts

What would this achieve?

0 LBA generally occurs when ID is made from ROM (i.e if SA cant read) or if SA has errors (like with bad Translator or non-native ROM). You should post terminal log, check HDD for any mechanical sounds during operation, and check that spindle remains powered after DRDY is reached

this is valid for pre F3 series only

hello.

I have a similar problem

terminal shows:





What can I do??

Dear Friend Damian
Its Very Easy I Dont Think U Need To Resoved This Problem For Any Rocket Science.
Experiance And Learning Make Every Case Easy.