I have an empty, working Seagate barracuda 7200.10 connected to a terminal for practice purpose. I have" F>" prompt but the terminal responds as invalide for all commands that I entered. When I try to change the levels using " /1" or other similar commands, the terminal shows error too. I have seen in this site that all discussions about terminals have" F3>" prompt, I do not know why I am getting the "F>". Could someone please give me a little push to the right dircetion.

Thanks.

_________________
A backup a day keeps DR away.

Thank you fzabkar.

Unfortunately for me, the first half of the document is in Russian and in PDF, which I do not understand and which I can not google-translate. Is there an English version of this document ?

Are you getting
F>
or
T>

Should be getting T>

If your getting F> it implies you are stuck at the firmware level (which only accepts a few commands eg ? )

and its surprising that the drive works at all (which you say it does)


and try R1 and R2
from the end of viewtopic.php?f=1&t=27679&start=20

Thanks xsoliman.

When I connect to Terminal, the first thing that I get is F> not T>

Command R2

gives the following response:


HM HM HM...........Code - FF Track 155c E.0.1AA Sns 1AA

If you getting F3 in promt on that drive you're not bad

_________________
Rescue IT Datarecovery service Sweden
Rescue IT Dataräddning Göteborg AB
http://www.rescue-it.se