Data recovery and disk repair questions and discussions related to old-fashioned SATA, SAS, SCSI, IDE, MFM hard drives - any type of storage device that has moving parts
June 26th, 2014, 7:56
Hello Friends ,
pC3K going into kernal mode
Help me if you have loader ?
model : WD5000AAKS-41YGA0
DCM : HHNCHT2MH8
RAM:
HDD Info reading........................ : Ok
Heads number............................ : 3
Cyl Count............................... : 128
Zone allocation table................... : HDDs RAM reading error - Device Error Detected: "VSCE PERM OVL NOT LOADED. LDR Upload is recomended"
ROM:
ROM reading............................. : Ok
ROM Data size........................... : 192 Kb
ROM version............................. : 58.A9D
ROM generation.......................... : 58.A9D
Link table version...................... : 01.0L.
Consolidated ROM version................ : 005800A9
ROM Modules:
Flash ROM dir reading................... : Ok
SA regions address...................... : by default
SA Translator loading................... : Ok
Heads configuration..................... : by map
Heads number............................ : 3
Heads number in use..................... : 3
Switched off heads...................... : No
Heads map............................... : 0,1,3
ROM Firmware version.................... : 005800A9
Service area:
Permanent overlay....................... : Not loaded
SA dir reading (ID)..................... : Drive is not ready
Drive is not ready
SA dir reading (ABA/CHS)................ : Module ID 30 reading error Data request error - Drive is not ready
Regards,
Nainesh
Powered by phpBB © phpBB Group.