We received a Maxtor 4D040H2 in that would not spin up, no sound, and upon supplying power to the drive, a very hot spot could be found on the pcb. We ordered a donor pcb with the following specs:
Patient:
Model: 4D040H2
Code: DAH017K0
MfgDate: 05MAY2002
Full Model: 4D040H2220541
PCB Controller: 040106000
4 Letters:N,M,D,B
Location: Singapore
Donor:
Model: 4D040H2
Code: DAH017K0
MfgDate: 29JUN2002
Full Model: 4D040H2220541
PCB Controller: 040106000
4 Letters:N,M,C,B
Location: Singapore
After a PCB swap, the drive will spin up but you can hear the heads thrashing back and forth a couple of times before parking, no detection (obviously). AFIK pre-Seagate Maxtor drives do not need any adaptive chip swaps but the results seem to disagree. Is there any extra information I missed that I may have needed to match in finding a suitable PCB for this particular drive?
Of course it is possible that there was some internal damage in addition to the PCB problems, I am just trying to cover all of the bases.
Pictures of (P)atient and (D)onor drives are below:
http://i.imgur.com/NK8SZAt.jpghttp://i.imgur.com/bA6bGCY.jpg