|
The failure of this drive surprised me, because it's not even four years old and it's only been used intermittently (maybe an hour per day on average).
The drive gives off a quick series of very quiet clicks (for about three seconds), a quick whine, and the same series of clicks again. Then it shuts down without ever spinning up the motor.
Opening the drive reveals nothing: No surface damage, heads are parked properly, both spindles and heads can be easily moved. Spindles twitch slightly during the click sequence, but nudging them by hand doesn't do anything either.
The mainboard doesn't show any damage. Zero-Ohm-resistors are fine, TVS diodes are blocking in one direction and show a voltage drop of 0.5V in the opposite direction.
Measuring the motor pins sequentially gives me 3x 0.8 Ohms and 1x 1.7 Ohms.
Changing the power supply gives me the same issue.
Isolating the preamps gives me the same issue.
Isolating the motor pins makes the startup attempt completely silent.
I suspected that the motor controller caps went dry and soldered an electrolytic cap to the 5V-tantalum caps next to the motor controller. Nothing.
What could possibly be wrong with this thing? I don't care enough about the data to try a PCB replacement, but I'm really baffled what I'm missing here.
|