melvin wrote:
Block SA and check modules. 32 for example.
Thank you so much for your reply, and I'm really sorry for my newbie questions.
Had blocked SA and performed a diagnosis. Had this output:
Technology mode key : ..........................: OK
Enter diagnostic mode. Please wait for completing diagnosis .
RAM:
Read HDD Info : ................................: OK
Heads number : .................................: 2
Head map : .....................................: 3
SA Cyl Count : .................................: 256
Serials Mark : .................................: 0xFE16
Control version : ..............................: 63B0
ROM:
Read Rom Infos : ...............................: OK
ROM Data Size : ................................: 192 Kb
ROM version : ..................................: 00.0JB
ROM generation : ...............................: 00.0JB
Link table version : ...........................: 03.0B
ROM Firmware version : .........................: 0000000J
ROM Modules:
Flash ROM dir reading : ........................: OK
The SA entry address : .........................: closed
Switched off heads : ...........................: Yes
Heads number : .................................: 0x2
Heads number in use : ..........................: 0x2
heads map : ....................................: 0,1
Load SA translator : ...........................: OK
Close 02 module ...
Get 02 access information : ....................: OK
Check 02 access data : .........................: OK
Close 02 module : ..............................: OK
Open 02 module ...
Get 02 access information : ....................: OK
Check 02 access data : .........................: OK
Open 02 module : ...............................: OK
Open 411 module ...
Get 411 access information : ...................: OK
Check 411 access data : ........................: OK
Open 411 module : ..............................: OK
load 01...
load 01 to HDD RAM...
The data source : ..............................: HDD
Get 01 module from HDD : .......................: OK
Load module list : .............................: OK
Load LDR : .....................................: Err
Load 02 module to HDD RAM : ....................: Failed
Zone allocation table : ........................: Err
Open SA access ...
Get SA access information : ....................: Failed
Failed to read the 01 module. Diagnosis cancelled!
Now we have the modules list, but I can't access any of those modules.
I really appreciate any other help. Thank you again.