pepe wrote:
The drive starts but gets stuck in bsy state if i removed the SSD board. However, attaching it live makes it get ready. pepe
Mine is quite the opposite. It starts without the SSD board. If i attach it live it goes BSY. If SSD board is connected from the beginning drive always BSY.
fzabkar wrote:
What is under the 771980 sticker on the main PCB?
Hynix H5PS5162GFR-S6C - 512Mb DDR2 SDRAM
Attachment:
2018_0611_023529_003.JPG [ 2.96 MiB | Viewed 12992 times ]
Marvell 88SE9171 - One-Lane PCIe 2.0 to One-Port 6 Gbps SATA I/O Controller
Attachment:
2018_0611_023438_001.JPG [ 3.06 MiB | Viewed 12992 times ]
Marvell 88i9441 - Soleil-H SATA SSHD Controller 6Gb/s SATA, Dual ARM On-Chip Processors, Encryption
Attachment:
2018_0611_023510_002.JPG [ 2.74 MiB | Viewed 12992 times ]
WD REDFIN A11SP - Motor Combo IC
Attachment:
2018_0611_023556_004.JPG [ 2.9 MiB | Viewed 12992 times ]
Winbond 25X40CLVIG - 4M-bit 2.5V Serial Flash Memory with uniform 4KB sectors and Dual SPI
Attachment:
2018_0611_023611_005.JPG [ 2.76 MiB | Viewed 12992 times ]
The SSD SATA lines come out of SSD
Attachment:
2018_0611_024727_007.JPG [ 3.35 MiB | Viewed 12992 times ]
Than go to the other side of PCB into the connector
Attachment:
2018_0611_024829_008.JPG [ 3.02 MiB | Viewed 12992 times ]
Than to the main PCB and into Marvell 88SE9171 chip.
Attachment:
2018_0611_033918_001.JPG [ 3.24 MiB | Viewed 12992 times ]
I could not find where the main SATA port lines go even thou i beeped all the components and pads on the pcb.
Attachment:
2018_0611_033948_002.JPG [ 3.1 MiB | Viewed 12992 times ]