WD4003FRYZ-01F0DB0 PROBLEM WITH PCB

[Maestro]

Hello everyone,

I have this WD drive with model WD4003FRYZ-01F0DB0 and original pcb is burned.

When i install donour pcb it gives model, serial, firm and capacity on pc3k but when i enter universal utility it gives error that drive is locked.

Can someone help me with issue?

Thank you all in advance

Regards

Maestro.

[digisupport]

Sorry to ask, have you remembered to transfer ROM or firmware from burned PCB to donor ?
Your drive is most likely a Hitachi in WD disguise.

[Maestro]

This is a photo of the pcb.

Can you point me where is rom chip or which chip to transfer?

Thanx

Maestro

Attachments

[michael chiklis]

Yep, that's Hitachi!

[fzabkar]

Did you check the fuses and TVS diodes?

There appear to be two ROMs located at the top left corner of the MCU in your photo.

[pcimage]

Hello everyone,

I have this WD drive with model WD4003FRYZ-01F0DB0 and original pcb is burned.

When i install donour pcb it gives model, serial, firm and capacity on pc3k but when i enter universal utility it gives error that drive is locked.

Can someone help me with issue?

Thank you all in advance

Regards

Maestro.

I bet it gives you the S/N of the donor and not the one on your bad drives label?

[pcimage]

Sorry to ask, have you remembered to transfer ROM or firmware from burned PCB to donor ?
Your drive is most likely a Hitachi in WD disguise.

Bingo!

[atamoro]

Hi all,

same problem here:


need to know if this is the chip to swap on new pcb??

Attachments

[fzabkar]

Hi all,

same problem here:


need to know if this is the chip to swap on new pcb??

no

[HddDonorMarket]

Yes I know it. recovered data before.
PCB no 0B36131

I have transfered both chips. And worked.
That chips smaller than common Rom chips. be carefull

ScreenShot_20210828233849.jpeg (43.2 KiB) Viewed 8397 times

chek this
https://www.data-medics.com/forum/threa ... -pcb.4027/