Seagate 7200.10 very slow read

[cheadledatarecovery]

The drive in question:

Seagate 500GB 7200.10
ST3500830AS
9BJ136-100
FW: 3.AFD
SITE: TK

The problem:
The drive reads all sectors very slowly >500ms. Every sector is accessible but can often require a retry. Essentially the drive needs time to become ready again between reads. It does not strike me as a degraded media/bad sector issue. I've disabled read ahead on the extractor but does not make a difference.

Firmware is OK and fully readable, no head mask errors in the command console.
I've swapped over the PCB with a exact match donor. Drive becomes ready as normal, but the slow read issue is the same. Any suggestions?

I'm just about to attempt to reverse clone. i doubt this will make a difference, but will post if it does.

Best wishes,
John

[quasimodo]

what is the terminal output?

[drc]

sounds like CE Log errors issue to me

[pepe]

I had the same thoughts...

[pcimage]

Does it make little "chirping" sounds while reading by any chance?

[quasimodo]

sounds like CE Log errors issue to me

Same thought here, therefore I wanted to see the terminal log to confirm.

[zebong]

if you can post terminal.

[cheadledatarecovery]

Yes, should have checked before, looks like CE log errors. Here is the output, I have not pasted all of it as it keeps going on and on...:

Reset
4096k x 16 DRAM
GALAXY - 1_Disk S-6D 09-22-06_15:48
HM SFI
!
(P)SATA Reset
AT Er 00 Nwt Er 37 RdWr 15bbd.02.01fc
ATA St 50 Er 01 Op 00 0,0000/0/00,00 01 00
Niwot: 97f29ff7 b8 97f29ff7.1.840 0000 005f 0000 0000
DiskAccess ReadSector EC=43 at 015bbd.02.01fc

CE Log ErrCode=37 LBA=2ad8be5c Type=5 Add To Pending 2ad8be5c

CE Log ErrCode=37 LBA=2ad8bc60 Type=6aAT Er 00 Nwt Er 43 RdWr 15bbe.02.0005
ATA St 50 Er 01 Op 00 0,0000/0/00,00 01 00
Niwot: 97f29ff7 b8 97f29ff7.1.840 0000 005f 0000 006a

CE Log ErrCode=43 LBA=2ad8c0e8 Type=4 Remove from Pending 2ad8c0e8
AT Er 00 Nwt Er 37 RdWr 15bbe.02.012c
ATA St 50 Er 01 Op 00 0,0000/0/00,00 01 00
Niwot: 9ff79ff7 b8 9ff79ff7.1.840 0000 005f 0000 006a
DiskAccess ReadSector EC=43 at 015bbe.02.012c

CE Log ErrCode=37 LBA=2ad8c20f Type=5 Add To Pending 2ad8c20f

CE Log ErrCode=37 LBA=2ad8c0e3 Type=6aAT Er 00 Nwt Er 43 RdWr 15bbf.02.03bf
ATA St 50 Er 01 Op 00 0,0000/0/00,00 01 00
Niwot: 97f29ff7 b8 97f29ff7.1.840 0000 005f 0000 006a

CE Log ErrCode=43 LBA=2ad8c925 Type=4 Remove from Pending 2ad8c925

CE Log ErrCode=43 LBA=2ad8c566 Type=6aAT Er 00 Nwt Er 37 RdWr 15bc0.02.0412
ATA St 50 Er 01 Op 00 0,0000/0/00,00 01 00
Niwot: 97f29ff7 b8 97f29ff7.1.840 0000 005f 0000 006a
DiskAccess ReadSector EC=43 at 015bc0.02.0412

CE Log ErrCode=37 LBA=2ad8cdfb Type=5 Add To Pending 2ad8cdfb

CE Log ErrCode=37 LBA=2ad8c9e9 Type=6aAT Er 00 Nwt Er 37 RdWr 15bc1.02.022b
ATA St 50 Er 01 Op 00 0,0000/0/00,00 01 00
Niwot: 97f29ff7 b8 97f29ff7.1.840 0000 005f 0000 006a
DiskAccess ReadSector EC=43 at 015bc1.02.022b

[cheadledatarecovery]

Yes definitely a CE Log error; I've removed the CE Log and now the drive is cloning nicely.

All the best,
John

[pepe]

That's it!!

pepe

[EnigmaSpace]

Yes definitely a CE Log error; I've removed the CE Log and now the drive is cloning nicely.

All the best,
John

HOW ??

ANY METHOD TO READ IT IN MRT . ?