Request : BoardView for WD PCB 2060-800041-003 REV P1

[zizsobhi2025]

Hello everyone,

I'm looking for a BoardView or schematic file for a Western Digital PCB with the following part number:

2060-800041-003 REV P1

The board is from a WD USB external hard drive, and I'm trying to either repair it or convert it to SATA to recover data. If anyone has the .brd, .bv, or any related diagram, I would greatly appreciate your help.

Thanks in advance!

[SWM]

I'm looking for a BoardView or schematic file for a Western Digital PCB with the following part number:

If you find it, share it. You can send it to me in PM.
https://forum.hddguru.com/viewtopic.php?f=1&t=42203
https://www.google.com/search?q=PCB+206 ... 03+to+SATA

Last edited by SWM on June 10th, 2025, 16:22, edited 1 time in total.

[fzabkar]

If the symptom is no power, the usual cause is dry solder joints at the zero-ohm resistor adjacent to the USB connector. Reflow the solder and you should be OK.

[instantmash]

If the symptom is no power, the usual cause is dry solder joints at the zero-ohm resistor adjacent to the USB connector. Reflow the solder and you should be OK.

I just made an account to say thanks! I suspected a power issue but finally took a second look with my new microscope and sure enough, that's the issue! Reflowed the solder and it works, no board swap needed.

IMG_20250708_171054_687 small.png (383.28 KiB) Viewed 479 times

[Pcokay]

Hello,

Many thanks, good catch, same problem here !