Data recovery and disk repair questions and discussions related to old-fashioned SATA, SAS, SCSI, IDE, MFM hard drives - any type of storage device that has moving parts
August 15th, 2005, 11:41
Hi, I have an ST320413A drive, it seems that it cannot load FW.
I paste the com log bellow. it starts the spindle unparks heads, then it pauses for a few seconds. Then come some clicks (the first $Head Mask.. line) and stops the spindle.
On the IDE terminal it doesn't get ready at all.
Can anyone give me a clue what to do, where to start?
Maybe COM commands?
thx,
pepe
Interface task reset
1024k x 16 buffer detected
U5 - 1_Disk 3.39 01-19-01 13:49
ATReset Power Cycling
Head Mask 0003 - Switch to full int.
Ready
$Head Mask 0003 - Switch to full int.
Ready
$Head Mask 0003 - Switch to full int.
Ready
$Head Mask 0003 - Switch to full int.
Ready
$Head Mask 0003 - Switch to full int.
Ready
$Head Mask 0003 - Switch to full int.
Ready
$Head Mask 0003 - Switch to full int.
Ready
$Head Mask 0003 - Switch to full int.
Ready
$Head Mask 0003 - Switch to full int.
Ready
$Head Mask 0003 - Switch to full int.
Ready
$Head Mask 0003 - Switch to full int.
Ready
$
August 15th, 2005, 22:59
how about the AGE of this hdd? can you use";" to check the state of hdd
August 16th, 2005, 1:29
Hi Jerry,
Thanks for your time.
$Age=50 Type=61 MxCyl=72C8 MxHd=1 MxSct=152 BSz=0800 TCode=0000
Any ideas?
pepe
August 16th, 2005, 2:55
Probably a bad head
pepe wrote:Hi, I have an ST320413A drive, it seems that it cannot load FW.
I paste the com log bellow. it starts the spindle unparks heads, then it pauses for a few seconds. Then come some clicks (the first $Head Mask.. line) and stops the spindle.
On the IDE terminal it doesn't get ready at all.
Can anyone give me a clue what to do, where to start?
Maybe COM commands?
thx,
pepe
Interface task reset
1024k x 16 buffer detected
U5 - 1_Disk 3.39 01-19-01 13:49
ATReset Power Cycling
Head Mask 0003 - Switch to full int.
Ready
$Head Mask 0003 - Switch to full int.
Ready
$Head Mask 0003 - Switch to full int.
Ready
$Head Mask 0003 - Switch to full int.
Ready
$Head Mask 0003 - Switch to full int.
Ready
$Head Mask 0003 - Switch to full int.
Ready
$Head Mask 0003 - Switch to full int.
Ready
$Head Mask 0003 - Switch to full int.
Ready
$Head Mask 0003 - Switch to full int.
Ready
$Head Mask 0003 - Switch to full int.
Ready
$Head Mask 0003 - Switch to full int.
Ready
$
August 16th, 2005, 3:18
run"." look at Trk=xxxx(yyyy),a(b),zzz(www) , that's running active logic cylinder(physical cylinder), head, sector . To see whether the head is bad
Powered by phpBB © phpBB Group.