Pinout Needed

[ddrecovery]

Anyone have a pinout for this?
Marking on the chip are KA02G1106.

Attachments

[Amarbir[CDR-Labs]]

Anyone have a pinout for this?
Marking on the chip are KA02G1106.

Well,
The Plastic Remove Job Needs a Pat on Your Back Brother ,Job Well Done .What Tools Are you Having

[ddrecovery]

Anyone have a pinout for this?
Marking on the chip are KA02G1106.

Well,
The Plastic Remove Job Needs a Pat on Your Back Brother ,Job Well Done .What Tools Are you Having

Thanks Amarbir I use a mix of fine grit sandpaper (the wet/dry type also called emery paper) and a fiberglass pencil. The pencils are very good indeed for this type of job. Just wear gloves when you use them.

[Amarbir[CDR-Labs]]

Anyone have a pinout for this?
Marking on the chip are KA02G1106.

Well,
The Plastic Remove Job Needs a Pat on Your Back Brother ,Job Well Done .What Tools Are you Having

Thanks Amarbir I use a mix of fine grit sandpaper (the wet/dry type also called emery paper) and a fiberglass pencil. The pencils are very good indeed for this type of job. Just wear gloves when you use them.

Well,
Commendable Work i Must Say again .Best of Luck With Recovery Of This Case ,Do Post If You Succeed