SP S55 - SATAFIRM S11

[Pi0tR]

Hi i have Silicon Power S55 with SATAFIRM S11 Error
im trying to boot this drive in save mode via MRT (short two pins on PCB) but disk is not ready
what am I doing wrong ?

[ccc]

Try to not short anything, power on the drive and enter the utility...does it work? Or it goes to BSY state?

[Pi0tR]

pins not shorted

and nothing more, unfortunately

[fzabkar]

Check the 3 supply voltages. Perhaps a missing NAND Vcc supply might produce the same symptom???

[ccc]

Ok. Show us the same screenshots but this time with pins shorted.

[Pi0tR]

Try to not short anything, power on the drive and enter the utility...does it work? Or it goes to BSY state?

im back to topic
wittout shorting i see this

[vx1]

Create the translator at this point and in the DE use "Read form active MRT Utility" as normal.

[Pi0tR]

100% sucess, thanks a lot !