HDD GURU FORUMS

Good morning,

1st: I am looking for such an SSD module: 256GB Adata xm11-v2
has anyone such a spare module in working condition ?
Offers welcome

2nd: Can anyone offer or suggest an adapter to convert this
proprietory connectors / ssd into standard SATA

Allthough it looks quite similar
- it IS NOT mSATA
and
- it IS NOT M.2.

It is smaller and has less pins on the contact - its used in the
ASUS Zenbook UX51VZ in pairs of 2 to build a raid

Thank you for assistance
***

Hello

I have a XM-11 module , but is only (128GB).

You are right.. They are a non standard interface.

Electrically it is simply 3.3V and SATA 2.0 nothing special there, but as far as the pin arrangement goes its different to anything else out there.

Personally I always manually connected to the device with a PC3K SATA-ATA adapter and a little jig I have made from a modified Mac-book air adapter.

Ok,
thank you - adapter found

and looks like I found also one of these (very expensive) ssd

+++

Can you give me a link as to were you found the adaptor? I have had no luck finding one yet

There is an offer on eBay even from an US reseller

check for offer # 261466874341

regards
+++