| HDD GURU FORUMS http://forum.hddguru.com/ |
|
| Sandisk Extreme 32GB SD Card with monolith http://forum.hddguru.com/viewtopic.php?f=10&t=31930 |
Page 1 of 1 |
| Author: | ddrecovery [ September 10th, 2015, 13:19 ] |
| Post subject: | Sandisk Extreme 32GB SD Card with monolith |
I am starting to get into monolith recoveries after cutting my teeth on flash drives and have a couple of questions. I have a Sandisk Extreme 32GB SD Card with monolith. I can’t tell if its type 4 or type 5 (PC-3000 Flash database), is there any way to tell? Do I need a oscilloscope or similar? I know the difference is bus size? From that I understand this chip needs external power at 2.3V, how best do I supply that to the reader? I have just completed a soldering course so can handle of the physical aspects of recovery, just need some additional technical knowledge. |
|
| Author: | arvika [ September 10th, 2015, 15:47 ] |
| Post subject: | Re: Sandisk Extreme 32GB SD Card with monolith |
It is one of the simplest monolith to solder. What type - just check it - solder wire and check ID. If reader is good, this chip do not need external power, just power from reader. |
|
| Author: | ddrecovery [ September 14th, 2015, 13:22 ] |
| Post subject: | Re: Sandisk Extreme 32GB SD Card with monolith |
arvika wrote: It is one of the simplest monolith to solder. What type - just check it - solder wire and check ID. If reader is good, this chip do not need external power, just power from reader. Thank you. I did get this one back. I was concerned that connecting the card with an incorrect set up may damage the card. Always looking after the clients data 
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|