OCZ Agility 3 not detected

[niccodemi]

Hi,

I've got ssd ocz agilityz 3 and the controller is a sf-2281. Disk worked fine for several years; since last power outage it is not detected anymore (even in bios); tried different computers, cables.
The SF-2281 chip gets quite warm to touch when powered up; other flash chips don't get warm at all.

This is the log from terminal

[ROM] PORRST
[ROM] Chip ID 0x200026BB

*** ROM Rev 20D Dec 20 2010 Build 288571 ***
[ROM] Try BCH[1]: CP=33 EC=54 EP=485
[ROM] Load CRP
*** CRP Rev 101 Jul 20 2011 Build 325474 ***
[ROM] Load FWR
▒▒▒▒g▒▒▒ހ
▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒
▒?▒▒

[pcimage]

Sandforce contoller (search it here) so EXTREMELY difficult to recover due to hardware encryption.

There is nothing DIY you can do with this.

Professional recovery would be at least $500 (slim chance) to several thousand (more likely) depending on the level of memory degradation.

[niccodemi]

Hi,

thanks for replying. Basically recovering data is not important to me at all (there was only OS installed on the drive). Is it possible to make disk functional again?

[fzabkar]

Basically recovering data is not important to me at all (there was only OS installed on the drive). Is it possible to make disk functional again?

http://forum.ru-board.com/topic.cgi?forum=84&topic=5360

[niccodemi]

Basically recovering data is not important to me at all (there was only OS installed on the drive). Is it possible to make disk functional again?

http://forum.ru-board.com/topic.cgi?forum=84&topic=5360

Thanks a lot. I followed video guide from 1st post and successfully reflashed drive.