HDD GURU FORUMS

Hello,

I have an ADATA 60GB SSD here. Here the firmware update with the official software of ADATA failed. Is there a way via Termial to reload the firmware?

If you don't need the data …

http://forum.ru-board.com/topic.cgi?forum=84&topic=5360

My Russian is unfortunately too bad to read it
The Data on The SSD is not needed.

Use Google's translator:

https://translate.google.com/translate?hl=&sl=ru&tl=de&u=http%3A%2F%2Fforum.ru-board.com%2Ftopic.cgi%3Fforum%3D84%26topic%3D5360

Restoring SSDs on a SandForce SF-2XXX controller (Video instruction):
https://www.youtube.com/watch?v=vSCr3UzyzhM

thx for you help.
I looked at the list and have 2 possible configurations. but which is the right one?

You can choose either. The lower user capacity will have correspondingly more overprovisioned space, resulting in higher performance.

https://www.seagate.com/au/en/tech-insights/ssd-over-provisioning-benefits-master-ti/

I can Say That... The SSD is alive again!
Thanks alot

Does anyone know if this SSD has a temperature sensor? I could not locate any on the board.

erebus wrote:Does anyone know if this SSD has a temperature sensor?

I don't recognise any discrete temperature sensor IC.

What is the marking on U73? Is it "F2C"?

Is there a temperature attribute in the SMART report?

The Marking is 14BBJ.
Smart say Temp. not Supportet and SSD Toolbox say Temp over 60000 Grad

erebus wrote:The Marking is 14BBJ.

That's U72.

MP6400DJ-01, adjustable Programmable-Delay Supervisory Circuit, marking 4Bxx, TSOT23-6:
http://www.mouser.com/ds/2/277/MP6400_r1.1-371744.pdf

I think this ssd has no temperature sensor.