| HDD GURU FORUMS http://forum.hddguru.com/ |
|
| Anyone seen this Controller? http://forum.hddguru.com/viewtopic.php?f=10&t=40416 |
Page 1 of 1 |
| Author: | ddrecovery [ September 21st, 2020, 18:50 ] | |||
| Post subject: | Anyone seen this Controller? | |||
Anyone know the pinout for this controller? IDE - 5019BSC-1 After some research it appears it may be an unbranded Alcor, but that is as far as I have got. NAND chip is just a blob under hard conformal. Any help would be appreciated.
|
||||
| Author: | fzabkar [ September 21st, 2020, 21:50 ] |
| Post subject: | Re: Anyone seen this Controller? |
It looks like the PCB is laid out for two controllers, "AU" (Alcor Micro) and "FC" (FirstChip). Perhaps you could find a known "FC" controller in a 24-pin package which matches the 5V, ground, 3.3V (?) and Data +/- pins? Then you could work backwards and translate the pinout of the IDE chip (like the Rosetta Stone). |
|
| Author: | melvin [ September 22nd, 2020, 7:34 ] |
| Post subject: | Re: Anyone seen this Controller? |
I had very similar one. Sadly it was dymanic XOR. Pinout should be easy to find. |
|
| Author: | pepe [ September 22nd, 2020, 8:19 ] |
| Post subject: | Re: Anyone seen this Controller? |
i had one as well, reversed the pinout (sent to Tim already), but as far as i can recall the job was stuck somewhere else. Maybe due to dyn xor as Melvin said... pepe |
|
| Author: | ddrecovery [ September 22nd, 2020, 9:54 ] |
| Post subject: | Re: Anyone seen this Controller? |
Thanks for the replies. As pepe said he sent me his pinout (much appreciated), so I will try today and let you know the outcome. |
|
| Author: | Amarbir[CDR-Labs] [ September 22nd, 2020, 13:50 ] |
| Post subject: | Re: Anyone seen this Controller? |
ddrecovery wrote: Thanks for the replies. As pepe said he sent me his pinout (much appreciated), so I will try today and let you know the outcome. Well, I Would Love To Nail This Case If i Had It  .
|
|
| Author: | Ihab [ March 3rd, 2021, 4:50 ] |
| Post subject: | Re: Anyone seen this Controller? |
Hi, did someone find the layout for this controller? I would need it to.... thanks |
|
| Author: | pcimage [ March 4th, 2021, 17:16 ] |
| Post subject: | Re: Anyone seen this Controller? |
http://www.flash-extractor.com/library/ ... 94_da__1x1 This IDE5019 appears to be a re-badged AU controller. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|