All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 5 posts ] 
Author Message
 Post subject: SKhynix M+B mSATA SSD not recognized
PostPosted: November 13th, 2022, 12:25 
Offline

Joined: November 13th, 2022, 12:23
Posts: 1
Location: United States
SKhynix SC300 M.2 2280 512 GB. There is no doubt this is not working. I've tried plugging it into a PCIe adapter card, USB adapter and now a SATA adapter. In the thermal the SH878104AA chip just gets a little warm. I tested all caps for any shorts and see no issues there. No missing components. No corrosion. My only guess is that this is a controller chip and would need to be replaced? I did already order a duplicate SSD that has that same chip. Not sure if that even works? Does it hold TRIM data? Just not sure on this. I realize this is a M+B key mSATA and I have plugged it up properly into the correct adapters that support it. I do run a professional computer and mobile repair shop but I'm limited on advanced data recovery. I don't have much experience and don't have pro tools. Willing to learn and invest. Any help or advice very much appreciated. Thank you in advance.


Attachments:
20221108_085033.jpg
20221108_085033.jpg [ 102.75 KiB | Viewed 2647 times ]
img_thermal_1667915471663.jpg
img_thermal_1667915471663.jpg [ 336.41 KiB | Viewed 2647 times ]
Top
 Profile  
 
 Post subject: Re: SKhynix M+B mSATA SSD not recognized
PostPosted: November 13th, 2022, 20:32 
Offline
User avatar

Joined: September 8th, 2009, 18:21
Posts: 15463
Location: Australia
The typical failure in SSDs is a "firmware panic" resulting from bad NAND.

The only DIY electronic options are to test for the presence of each of the onboard power supplies.

If you can locate the "ROM mode" or "safe mode" shorting points, then this will test for basic sanity in the flash controller.

Some SSDs have a "key" in the controller. Transplanting such a controller to a donor PCB would be unsuccessful.

_________________
A backup a day keeps DR away.


Top
 Profile  
 
 Post subject: Re: SKhynix M+B mSATA SSD not recognized
PostPosted: November 13th, 2022, 21:18 
Offline
User avatar

Joined: May 13th, 2019, 7:50
Posts: 907
Location: Nederland
fzabkar wrote:
The typical failure in SSDs is a "firmware panic" resulting from bad NAND.

The only DIY electronic options are to test for the presence of each of the onboard power supplies.

If you can locate the "ROM mode" or "safe mode" shorting points, then this will test for basic sanity in the flash controller.

Some SSDs have a "key" in the controller. Transplanting such a controller to a donor PCB would be unsuccessful.


Franc, in your opinion should 126F even be considered (too) hot?

_________________
Joep - http://www.disktuna.com - video & photo repair & recovery service


Top
 Profile  
 
 Post subject: Re: SKhynix M+B mSATA SSD not recognized
PostPosted: November 13th, 2022, 21:29 
Offline
User avatar

Joined: September 8th, 2009, 18:21
Posts: 15463
Location: Australia
Arch Stanton wrote:
Franc, in your opinion should 126F even be considered (too) hot?

That's 52C. I've regularly seen temperatures go higher than 70C (in the user forums) before the SSD starts throttling. This is especially true for NVMe SSDs.

GSmartControl will report the temperature history for those SATA devices that support it. The logs may also report the trigger points and the number of times they've been exceeded.

_________________
A backup a day keeps DR away.


Top
 Profile  
 
 Post subject: Re: SKhynix M+B mSATA SSD not recognized
PostPosted: November 15th, 2022, 22:30 
Offline

Joined: August 18th, 2010, 17:35
Posts: 3636
Location: Massachusetts, USA
The most common problem with SK Hynix, as with most SSDs in general, is NAND flash chip degradation.

The controller on your SSD is fine.

The firmware design on Hynix is complex and there are virtually no solutions for that type of problem on that model, sorry.

_________________
Hard Disk Drive, SSD, USB Drive and RAID Data Recovery Specialist in Massachusetts


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 5 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: Google [Bot] and 17 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group