Micro SD card pin out

[terminator2]

Hi Friends
I have got a 64gb microsd card which is not detected. When I connect it to card reader LED on card reader blinks for a second and goes off.
I think something is short inside .
I want to know how can I check card using multimeter (by checking continuty)

[arvika]

VCC-GND - check resistance.
Card is hot after power on?

[terminator2]

VCC-GND - check resistance.
Card is hot after power on?

When it comes to Nand arvika is last word , Master of masters .
Thanks a lot arvika
I have checked VCC & GND ( pin 4 and 6) they are open ( short) , I think its game over card is non recoverable.

[arvika]

I have checked VCC & GND ( pin 4 and 6) they are open ( short) , I think its game over card is non recoverable.

Sometimes not end If you have, you can use thermal camera or freezer and check which place is hottest the fastest. And if possible remove short. Such cases are very hard but we have success statistically for ~50% cases.

[terminator2]

I have checked VCC & GND ( pin 4 and 6) they are open ( short) , I think its game over card is non recoverable.

Sometimes not end If you have, you can use thermal camera or freezer and check which place is hottest the fastest. And if possible remove short. Such cases are very hard but we have success statistically for ~50% cases.

WO Great