HDD GURU FORUMS http://forum.hddguru.com/ |
|
Cricial MX500 (ct2000mx500ssd1) http://forum.hddguru.com/viewtopic.php?f=10&t=43135 |
Page 1 of 1 |
Author: | Lardman [ February 16th, 2023, 16:07 ] |
Post subject: | Re: Cricial MX500 (ct2000mx500ssd1) |
Check the zero ohm resistor for a start, then the efuses, then on to the voltage checks at the inductors. What's the current draw? |
Author: | fzabkar [ February 16th, 2023, 16:27 ] |
Post subject: | Re: Cricial MX500 (ct2000mx500ssd1) |
MP5016H, Monolithic Power, 2.7V - 22V, 0.7 - 5A, Current Limit Switch with Over-Voltage Clamp and Reverse Block, marking FG, QFN10: https://www.monolithicpower.com/media/document/MP5016H_r1.0.pdf https://images.anandtech.com/doci/12263/imgp0157.jpg |
Author: | hdd_guru [ February 17th, 2023, 0:25 ] |
Post subject: | Re: Cricial MX500 (ct2000mx500ssd1) |
You guys are a wealth of knowledge. Thank you so much. Will study and try. Thank you! Best wishes to all. |
Author: | DataLab RSA [ March 13th, 2023, 7:49 ] |
Post subject: | Re: Cricial MX500 (ct2000mx500ssd1) |
did you found the short because last week I had the same problem with the same SSD and found the short next to one of the NAND units and just removed the shorted cap c88 and c91 they warmed up alot and managed to get access to all data. Will send picture later |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |