Hello,
on spider board and mr21 adapter the card become no ID.
Have anyone an idea about the PINOUT for this card?
Thanks
| Attachments: |
|
PINOUT.jpg [ 361.92 KiB | Viewed 4787 times ] |
| HDD GURU FORUMS http://forum.hddguru.com/ |
|
| PINOUT for SanDisk extreme micro SD Card 64GB http://forum.hddguru.com/viewtopic.php?f=10&t=43704 |
Page 1 of 1 |
| Author: | WalRos [ September 26th, 2023, 9:09 ] | ||
| Post subject: | PINOUT for SanDisk extreme micro SD Card 64GB | ||
Hello, on spider board and mr21 adapter the card become no ID. Have anyone an idea about the PINOUT for this card? Thanks
|
|||
| Author: | melvin [ September 26th, 2023, 10:51 ] |
| Post subject: | Re: PINOUT for SanDisk extreme micro SD Card 64GB |
Should be standard 7x3 in my opinion. If it's not shorted and gives no ID when soldered or in adapter than it should be checked with logical analyzer. BTW. MR-21 has alternative pinout too. Did you read the manual how to use this adapter? |
|
| Author: | Gregory [ September 26th, 2023, 14:22 ] |
| Post subject: | Re: PINOUT for SanDisk extreme micro SD Card 64GB |
This is standard pinout but this Micro SD card use ECC LDPC + probably is encrypted, data cannot be recovered from it. |
|
| Author: | arvika [ September 26th, 2023, 16:45 ] |
| Post subject: | Re: PINOUT for SanDisk extreme micro SD Card 64GB |
Chip-off impossible due to LDPC. But card have some corrosion or damage connector pads. Try fix it, ant maybe you get the data. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|