PCB Exchange problem Hitachi Plat 80 GB

[ccamargol]

Hi

I have a Hitachi Plat of 80 GB with the damaged PCB.
I got another PCB and I replaced it to the hard disk, rewrite the NV-RAM.

Now the hard disk recognizes it totally (Model, firmware, modules, etc)
I made an SA Checking Test and everything was perfect.

When I try to extract the data or when I make a recalibration, the disk presents
the following sound: tac, tac, tac, tac.... and power off

Because this happens?

Carlos.

[Creator]

What shows express utility?
Maybe you could clone the data without recalibration?

[ccamargol]

It didn't work cloning the hard disk.
Some other idea?

[beto]

Did u tried to read a surface scan? maybe there are bad surface or a bad head

[Creator]

It didn't work cloning the hard disk.
Some other idea?

Try to run express test from universal utility. Do you know how to do it?
Or use magic key....Alt+V

[ccamargol]

Hi,
very bad in express test...
please help me!!!

Attachments

imagen.doc

(119.5 KiB) Downloaded 650 times

[harddrivespecialist]

Try the end , middle. See if you have same results.

[beto]

Could be a bad head zone, tried to build a head map, and check, that

[ccamargol]

It didn't work head map the hard disk.
Some other idea?

[harddrivespecialist]

It didn't work head map the hard disk.
Some other idea?

Another option is to send it for a professional recovery.