Switch to full style
Discussions related to PC-3000
Please no pirated software here!
Post a reply

WD400BB-77AUA1 - PCB dead !!!

September 5th, 2009, 7:41

Hi to all,

Have this disk WD400BB-77AUA1, when i connect to the udma it stays BSY forever.

So i found a similiar PCB

Patiente: 000 001003-001 G
Donor : 000 001003-000 C


When i change it , i could have ID, serial size, all the modules are ok in the utility, and i see two heads 0 1
head-test.jpg
head-test.jpg (9.49 KiB) Viewed 6989 times



I test the SA copy in the Composite reading , Copy 0 , Copy 1, and all the modules are green.

The info from service tracks i have this error but i think is normal for this model

Cyl -9; Head 0.......................... : Ok
WD Techno Read Error C/H/S: -9/1/280 Device Error Detected 59/40 (UNC)
.
.
WD Techno Read Error C/H/S: -9/1/327 Device Error Detected 59/40 (UNC)


Cyl -20; Head 0......................... : Ok
WD Techno Read Error C/H/S: -20/1/1 Device Error Detected 59/01 (AMN)
.
.
WD Techno Read Error C/H/S: -20/1/519 Device Error Detected 59/01 (AMN)

Cyl -20; Head 1......................... : Ok


When i start in DE and build the head maps it appear 3 Heads.
wd-head-map.jpg
wd-head-map.jpg (4.5 KiB) Viewed 6991 times



i start to clone, and i just can clone 41 215 sectors, after disk it give error reading any sector


Anyone have an opinion about this.


Thanks
ZeBong

Re: WD400BB-77AUA1 - PCB dead !!!

September 5th, 2009, 8:36

Hi,
This HDD will have 3 heads enabled...
PS Probably U use PCB from 20GB or 30GB donor...

Mikippp

Re: WD400BB-77AUA1 - PCB dead !!!

September 6th, 2009, 11:11

change the ROM from original pcb to this donor pcb .

Re: WD400BB-77AUA1 - PCB dead !!!

September 7th, 2009, 10:02

Thanks to all,

I prefer to try first just to write a ROM do the patient PCB.

Anyone have this ROM, WD400BB-77AUA1


Thanks
ZeBong

Re: WD400BB-77AUA1 - PCB dead !!!

September 7th, 2009, 10:31

Hi,
When i change it , i could have ID, serial size, all the modules are ok in the utility, and i see two heads 0 1


U not need ROM...
U must enable more 1 head...

PS In this PCB ROM may be saved in Flash, or in Eprom...

Mikippp

Re: WD400BB-77AUA1 - PCB dead !!!

September 7th, 2009, 16:37

Thanks Mikippp, the donor PCB was from a 20GB disk.

Can anoyone knows how much heads have this model ?

I enable one more head, and now in DE it appear 4 Heads.

Tomorow i will enable other Head, but would like to know if this model have 4 heads.


Thanks
ZeBong

Re: WD400BB-77AUA1 - PCB dead !!!

September 8th, 2009, 6:20

Enable 4 Heads, and cloning 100%


Thanks Mikippp :D
Post a reply