HELP!!! SSD Micro!!!

[olinyer]

Hi,

I hope you are doing great.

I have this SSD Storage Micro of 256GB (Lingston Technology) i have connected to a adapter SSD to SATA, it is very hot and PC3000 wont autodetect.

Not sure next steps and it would be great a suggestion.

Thank you for the help.

Best regards,

[F_ARG]

Hi olinyer, Have you got a picture of it? Which part is getting hot? Main controller, memories?

Best

F

[fzabkar]

A photo of the adapter would be advisable, IMHO. It could be that the wrong adapter is being used.

[olinyer]

adding pic.

the memories (two NAND Chips) are the one getting very hot

i thought in the kind of adapter as well

thank you for the help.

Best regards,

Attachments

[F_ARG]

Hello! I can t realize looking at the pictures...but were the memories reworked (unsoldered and re-soldered)?
Only 2 of the 4 memories are getting hot?

Best,

F

[fzabkar]

Here are photos of the adapter:
http://cdn1.image-tmart.com/prodimgs_v2/8/8101/0925/81010925/M817-mSATA-SSD-to-25-SATA-Adapter-Card-25cm_800x800.jpg?1388195215 (component side)
https://contestimg.wish.com/api/webimage/54002853ecdd3054d195a166-4-large.jpg (back)

The voltage at the tab of U1 (LT1084-33) should be +3.3V.

AFAICT, the SSD (Kingston SMSR150S3/256G mSATA) is a RAID with a separate SSD on each side.

Phison PS3108-S8-I controller
Elpida EDJ2116DEBG 2Gbit DDR3 SDRAM
2 x Toshiba TH58TEG8DDJBA82 NAND flash (64GB ?)

The adapter expects to see a single SSD. Therefore I would be very concerned with the pinout. Perhaps it is non-standard? I would determine the ground pins with a multimeter, and also confirm the +3.3V pins by testing for continuity with U1.


EDJ2116DEBG, Elpida, 2Gbits DDR3 SDRAM, 128Mwords x 16bits, 1.5V:
http://tabreview.ru/content/pdf_docs/El ... G_DJ_F.pdf

LT1084-33, Linear Tech, 5A, 3.3V, LDO Regulator:
http://www.farnell.com/datasheets/1941079.pdf

PS3108-S8 product brief:
http://www.phison.com/English/newProductView.asp?ID=237&SortID=63

Operating Voltage: 0.9 ~ 3.6V
Built-in Regulator that supports 3.3V/1.8V Flash I/O