Seagate age99

[mulan]

HI
I have a segate ST3500841A fw3.AAE(TONKA4D) with many bad sectors.
in the beginning i tried logical scan and hide to p-list butt did not work because i keep getting a write error at plist writhing
so i tried self scan butt the test ended in age99(i think is an error). i tried for 2 times( same result)

Begin Test 99
ASCII logging on
ASCII logging off
ASCII logging on
TestIndex=20/111, Stage 1/1, Prev test 56, Next test 10
ASCII logging off
Test=99, Feature=0, cumhlth=0008, curhlth=0000
OkEnd Test 99

T>
now i rewrite cert, overlay, vendor and the hdd is detected ok butt the reserved track list,user track list and, alt list are empty and the hdd is full of bad sectors
i have attached a file with the self scan report
anyone know haw to repair this drive?
thanks

Attachments

seagate500G.txt

(214.73 KiB) Downloaded 958 times

[mulan]

nobody knows?

[Tomset]

continue ^T

[chet3000]

N50,,22
T50
AND THEN N10,,22

.....WAIT FOR FINISHING

[suntom]

HI
I have a segate ST3500841A fw3.AAE(TONKA4D) with many bad sectors.
in the beginning i tried logical scan and hide to p-list butt did not work because i keep getting a write error at plist writhing
so i tried self scan butt the test ended in age99(i think is an error). i tried for 2 times( same result)

Begin Test 99
ASCII logging on
ASCII logging off
ASCII logging on
TestIndex=20/111, Stage 1/1, Prev test 56, Next test 10
ASCII logging off
Test=99, Feature=0, cumhlth=0008, curhlth=0000
OkEnd Test 99

T>
now i rewrite cert, overlay, vendor and the hdd is detected ok butt the reserved track list,user track list and, alt list are empty and the hdd is full of bad sectors
i have attached a file with the self scan report
anyone know haw to repair this drive?
thanks

/T
N10,,22
ctrl+t

RUN TEST,until the test end

DON'T power off,write ovelay ,vendor,save to disk

this disk will be repaired.

good luck for you

[rameez]

These newer seagate drives use two selfscan after first finishes u have to give CTRL+T to start with the second one .

[guru]

It's at test 99 when the past tests are checked and overlay's etc are loaded in the factory