Fujitsu MHV password

[pkure]

i have a fujitsu MHV hard disk,it has been set password,how to use PC3000-UDMA clera the passwrod? on adapter pc-2 card how to set jump ? and,how to use PC-FUJ.SATA?


hard disk interface:IDE

thanks!

[mr_spokk]

Hi,
UDMA can't unlock some drives in that Fujitsu family...
I have one myself and have been talking to ACE about this and they didn't have any solution of it yet.
But you can try: No jumpers on the pc-card, test menu/Service information/work with SA/Security subsystem/Password erasing

Regards/ Bosse

[coffeebean]

Ask Atola, ACE, Salvdata and some others if they support (or will support) disable security on ALL MHV models, would be interesting to know.

[pkure]

clear password,i had been try it,this opreation can't remove the password

who can help me?!!

[msurgeon]

Copy module SU from a donor (unlocked) to the locked drive. Should do the trick.

[coffeebean]

Hi msurgeon,

Did you read what mr_spokk wrote ?

[Doomer]

Some MHV drives can be unlocked with re-writing SU, some cannot
It depends of firmware revision

[msurgeon]

Hi msurgeon,

Did you read what mr_spokk wrote ?

Yes. I've successfully unlocked MHV2080AH with this method. I can't vouch for all MHV models.

[coffeebean]

Hi msurgeon,

As mr_spokk wrote some MHVs can allow typical read of SU and SM and quite a few MHVs do not.

[pkure]

thanks again

[pkure]

Copy module SU from a donor (unlocked) to the locked drive. Should do the trick.

I will try it