Hello

I turn on this drive and it get ready but don´t recognize the ID info.. With a hot swap I was able to copy the tracks and convert them to modules but the module 11 (LDR) is missing so I think if I get a compatible LDR I can detect the hard drive and recover the data.
Let me know if some one can get this LDR.

Thanks

Here for you. Hope it is helpful for your working.

RG,
Skype: hddselftest
Email: hddselftest@gmail.com

_________________
Best Regards,
SkypID: hddselftest
Email: hddselftest@gmail.com

Hello

Thanks selftest but this loder was from a 000500AS version. This is not compatible.
Someone can supply this loder?

Thanks

hi,
000500AP i have. please feel free to contact me by email or skype if need. thanks.

_________________
data recovery service[/b]

Hello

Thanks but from that version I have it to.
I´m still looking for this loder, I was able to read all the firmware beside the module 11.
With out it I can´t do anything. I tried to do a smart swap with other drive but the result was negative.

Thanks

Either you make hotswap wrong, or there is other problem somewhere else.

Try this...

">Techno mode key
>Techno mode key......................... : Ok
>
>RAM:
>HDD Info reading........................ : Ok
>Heads number............................ : 6
>Cyl Count............................... : 170
>
>Zone allocation table................... : Ok
>SA SPT.................................. : 1325
>
>ROM:
>Flash Dir reading....................... : Ok
>ROM reading............................. : Ok
>ROM Data size........................... : 192 Kb
>ROM version............................. : 05.C5E
>ROM generation.......................... : 05.C5E
>Link table version...................... : 04.3F.
>Heads configuration..................... : by map
>Heads number............................ : 6
>Heads number in use..................... : 6
>Switched off heads...................... : No
>Head map................................ : 2,3,4,5,6,7
>
>ROM Firmware version.................... : 000500BM
>Service area:
>SA dir reading.......................... : Ok
>SA Copies avalabled..................... : Copy 0,Copy 1
>
>Configuration reading................... : Ok
>Master Password......................... : has not been set
>User Password........................... : has not been set
>
!SA Firmware version..................... : 000500C5

_________________
PC Image Data Recovery
http://www.pcimage.co.uk

New!! HDD-PCB.COM for all your PCB and donor HDD requirements!

Sorry guys.. I just saw this messages today..

hddguy

The problem is that I´m using a drive from different rom version.. I can do all precess until I try to copy all the modules..

pcimage

Thanks for the reply. I tried to use it but is not compatible.

Still looking to find the same rom version or I can accept ideas

Thanks

Here it is if you still need it.