| HDD GURU FORUMS http://forum.hddguru.com/ |
|
| SEAGATE SELFSCAN http://forum.hddguru.com/viewtopic.php?f=11&t=10528 |
Page 1 of 1 |
| Author: | zebong [ November 20th, 2008, 15:53 ] |
| Post subject: | SEAGATE SELFSCAN |
Hi, anyone know this Afther a selfscan it appear´s this message: Interface task reset 1024k x 16 buffer detected SNOWMASS - 2_Disk 3.19 11-20-01 12:12 Power Cycling ATReset Head Mask 000F - Switch to full int. Spin Ready Begin Test 08 Not Power Cycling SkpCylList deleted Sys= 7000-7028 02B9 SPTK on sys trks <empty> drive must be reformatted EP=0, TA=0, HiGain=1, OTRd=0, Early Rd=0, Splash=1, Reload=1, VCO=1, MRBias=1 Bst/Zap=0, SrvoThrsh=1, RunOut=1, MaxECC=1, ECC 2=1, ECC 1=1, ECC 0=1 Data=FF, Write=80, ID=FF Thanks ZeBong |
|
| Author: | networkpc3000 [ November 20th, 2008, 17:08 ] |
| Post subject: | Re: SEAGATE SELFSCAN |
are you sure it's complete? i don't think so! |
|
| Author: | rameez [ November 21st, 2008, 17:18 ] |
| Post subject: | Re: SEAGATE SELFSCAN |
Let the test complete test 8 takes alot of time be petient . |
|
| Author: | jono-ats [ November 28th, 2008, 9:58 ] |
| Post subject: | Re: SEAGATE SELFSCAN |
I've never had much luck with Seagate's selfscan. I think it should be renamed, "self-destruct." I've used it with drives that had problems. After running the test(s), the drives would always be busy and never come ready. Impressive amount of test messages from terminal mode, though! |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|