The drive is Not Clicking, when connected to ACE tools, the Terminal :

Interface task reset
4096k x 16 buffer detected
MERC2 - 1_Disk 0.02 12-22-05 16:43
Head Mask 0F,01 - Switch to full int.
Spin Ready
Dwell Cyl - 0A1D/0603/061C

Burst 0001ERR Read App Code

F>
F>
e c r = 0 0 1
e c r = 0 1 0
e c r = 0 1 1
e c r = 1 0 0
F>

The Drive does not go ready, only BSY register is on,
Please help
Thank you

might be bad/dirty head 0 or all four copies of appcode damaged (I have seen such thing...)

pepe

_________________
Adatmentés - Data recovery

Tried to check on F if its possible to read system sectors looks liks problem on that area

Hi, I have some problem... disk spin up but state is BSY

T>Pgm=00 Trk=FFFFF(008CA:00[01C97]).0(0).051(051) Zn=0 Err=00 ErCt=0000 Hlth=0008 CHlth=0000 Ready LBA=0000024A
Age=50 Type=06 MxCyl=11BB4 MxHd=3 MxSct=339 BSz=2000 TCode=FEFAFDF9

T>F
DiskAccess ReadSector EC=43 at ffffffff.00.0051
DiskAccess ReadSector EC=47 at ffffffff.00.0051

T>(P)DiskAccess ReadSector EC=43 at ffffffff.00.0051
DiskAccess ReadSector EC=43 at ffffffff.00.0051


Help me please

weak heads, but u probably u get sectors by "hardware control" even i can see at u terminal log, its reading sector into the buffer

Regards

Hola Beto,
Veo que eres de Mexico, yo estoy ubicado en Bogotá. Dime como puedo acceder a los sectores por Controld e hardware con este problema?, ya has solucionado antes este problema?
Carlos

PM please