| HDD GURU FORUMS http://forum.hddguru.com/ |
|
| Maxtor Firmware help http://forum.hddguru.com/viewtopic.php?f=11&t=15563 |
Page 1 of 1 |
| Author: | asitren [ April 24th, 2010, 0:47 ] |
| Post subject: | Maxtor Firmware help |
I am a novice in dealing with some problems during the drive hope to help busy I use PC3000 under the SA testing and recovery scans the UBA ID SIZE MODULE IMPORTANCE READ HEADER CS 496 64 1 MAXATG B YES ERROR OK 690 7B 8 FW DR YES OK ERROR Errors leading to these two places can not partition the hard drive firmware can be solved brush it? Hard drive model is 4D040H2220311-KMBB is hard to buy in Asia, which friends have this type of firmware hope to help to help pass the next question also want to tell me which Under 4D040H22205B1-NMDB-B9FDB-68A3 these numbers represent the hard disk What sense |
|
| Author: | asitren [ April 24th, 2010, 2:04 ] |
| Post subject: | Re: Maxtor Firmware help |
How to solve UBA ID SIZE MODULE IMPORTANCE READ HEADER CS 496 64 1 MAXATG B YES ERROR OK 690 7B 8 FW DR YES OK ERROR These two areas in question Model is 4D040H2220311-KMBB |
|
| Author: | asitren [ April 24th, 2010, 2:05 ] |
| Post subject: | Re: Maxtor Firmware help |
Firmware Who can give a thank you |
|
| Author: | hddguy [ April 27th, 2010, 6:45 ] |
| Post subject: | Re: Maxtor Firmware help |
These should be repairable within the Maxtor uility. the data inside is probably OK, just header on 1st module, and checksum on 2nd. If you cannot do this, then I suspect no advice here will be of any use to you |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|